Home > Printer Error > Printer Error 54.16

Printer Error 54.16

The control panel will display SELECT LANGUAGE . Reboot the printer. Press (Select) to access the Menu on the Control Panel. In some cases, electrical noise in the cable can corrupt data during transmission to the printer. Source

Action Press (Select) to clear the message and continue. The control panel will display COLD RESET . Watch the control panel. Remove the formatter board. http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-bpl11648

The printer will perform a cold reset and then continue its power-on sequence. Turn the printer off, and turn it on again. Action Press (Select) to clear the message and continue printing.

Replace the color registration detection sensor asm. alternates with TO CONTINUE PRESS Description The flash DIMM or hard disk storage device is full. Action Turn the printer off, and turn it on again. Watch the control panel.

Action Turn the printer off, and turn it on again. If the 49 error returns, turn the power off, and then unplug the printer. top 53.X0.ZZ PRINTER ERROR TO CONTINUE TURN OFF THEN ON Description An error has occurred in the onboard RAM. see this here Verify accessory connection 57.X PRINTER ERROR A fan failure was detected.

If this message persists, contact an HP-authorized service or support provider. If this message persists, contact an HP-authorized service or support provider. Pull paper by bother corners to remove it. Press (Select) to select CONFIGURE DEVICE .

Turn on the printer. http://www.copytechnet.com/forums/hp/47016-hp-laserjet-5550-error-54-16-help.html The printer will perform a cold reset and then continue its power-on sequence. Continue holding the green check button until the Ready, Data, and Attention lights flash once, and then stay on steady. Reconnect the connectors of the printcartridge interface PCA (yellow and magenta). 2.

top 80 ERROR Description If the printer is exhibiting an 80 error, please try the following steps to resolve this issue. this contact form Add × Loading... The control panel will display COLD RESET . Wait for printer prompt to install the black print cartridge.

Clean the color registration detection sensor above the black print cartridge if the error does not clear. Replace any defective sensors or flags. 3. Watch the control panel. have a peek here The control panel will display SELECT LANGUAGE .

Status messages reflect the current state of the printer. All Rights Reserved. Try a different power cord.

Description Non-HP yellow print cartridge installed.

top 58.3 PRINTER ERROR FOR HELP PRESS alternates with TO CONTINUE TURN OFF THEN ON Description A CPU error reading a memory tag was detected. top 13.12.00 JAM IN DUPLEX PATH X For help press ? Check the printer’s configuration. 3. The control panel will display COLD RESET .

Action Ensure the print cartridge is a Genuine HP cartridge. When the memory starts counting, press and hold the green (Select) button. These messages typically alternate with the READY or STATUS messages and remain displayed until the (Select) button is pressed. Check This Out Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well-preserved body, but rather to skid in sideways - Coke in one

The control panel will display COLD RESET . If this message persists, contact an HP-authorized service or support provider. If this message persists, contact HP. We know that you don't want to spend hours trying to figure out a printer problem.

If this message persists, contact HP. When the memory starts counting, press and hold the green (Select) button. Check sensors and flags for proper operation 14 No cartridge There is no toner cartridge in the printer, or this message indicates the possibility of a broken or damaged toner cartridge. Press (Select).

The printer will perform a cold reset and then continue its power-on sequence. There may be a problem with the printer's fuser, or inadequate external or internal power supply/line voltage. 50.5 An inconsistent fuser error has occurred, possibly due to an inadequate external or